技術中心
Technology Center
當前位置:網站首頁 > 技術中心 > 技術詳情
使用注意事項
2017-06-16 16:28

棚板在運輸和儲存時,就保持直立置放禁止疊放.在任何情況下應保持棚板干燥.

本廠棚板表面噴涂的白色涂料經燒結后,正常可使用3-6個月,如表面白色涂料需更換,可使用本廠調配的涂料,在噴涂前盡可能將舊涂料面清除干凈后,再以噴槍噴刷施工,厚度為0.4-0.6mm為宜.

噴涂施工后的棚板,必需待其完全干燥后,方可使用.

坯體置于棚板上,需特別注意坯體需完全干燥,產品底部接觸棚板部分,就將釉料擦拭干凈,以免粘瓷.

臺車裝載時,耐火柱宜保持一直線,以免因支撐點不同,而影響棚板的壽命.

臺車裝載時棚板與棚板之間的距離,視坯體高度給予保留適當空隙,10-20mm為宜,坯與坯之間也需保留適當間隙,不可擠在一起或集中在某處,使窯內燃燒的火焰及空氣對流更加順暢.

棚板正常使用時切忌急速冷及急速熱升溫,以免棚板龜裂,因此在燒成時間及溫度的設定應特別注意.

用戶在使用過程中如有疑問,請及時與我們或供應商聯系,我們良好的售后服務一定會使您滿意.

 

Please keep shack plate vertical during transportation and storage ,and keep it dry at any time.

 

The calcined white coating on shack plate is offective for 3-6 months.pleaseuse the coating specially made up by our factory if coating replacement is needed.remember to clear old coating completely,and then paint in thickness of 0.4-0.6mm with spraygun.

 

Nowly painted shack plate can not be used untilit is completely dry.

 

When embryo is placed on shack place ,be careful to keep embryo dry.when produce bottom contacts shack plate ,please clear glaze off to avoid glaze strickiness.

 

During installation,fire-resisting colunm should be in straight ling because inconsistent supporting points shorten shack plate’s  life.

 

During installation,appropriate space should be kept between shack plates ,preferably10mm-20mm,approriate space should also be kept between embryse so sa to keep fire buring more completely and air comvection more smoothly in kiln.

 

Shack plate can never be cooled or heated quickly ,otherwise shack plate will be splitted, thus special attention should be paid to temperature and product  completion.

 

Please contact your supplier or the factory for any questions .our after sale service shall definitely satisfy you.

產品推薦 Product recommend
上海11选5开奖结